Mobile scissor lift parts is a kind of aerial work machinery equipment. With the increase of market demand, mobile scissor lift parts are more and more widely used in people & #39;s life and work. So, how to operate mobile scissor lift parts safely?
1. Before work, carefully check the scissor lift parts, focusing on checking whether the screw connection is reliable, whether the hydraulic pipeline components are leaking, and whether the wire contacts are loose or damaged.
2. Voordat u de onderdelen van de schaarhoogwerker optilt, plaatst u de vier - hoekpoten. De vier poten moeten stevig worden ondersteund op de vaste grond en de werktafel moet in horizontale staat worden afgesteld. Schakel de stroom in, het indicatielampje moet branden. Start vervolgens de motor, de oliepomp werkt, til één of twee keer onbelast op en neer en controleer of alle onderdelen normaal werken voordat u met de werkzaamheden begint. Als de temperatuur lager is dan 10 ℃, moet de oliepomp 3 - 5 minuten werken en de oliepomp kan alleen normaal werken nadat is bevestigd dat deze goed werkt.
3. After entering the platform, the operator should close the guardrail door, insert the latch, and fasten the safety rope. The center of the load should be located at the center of the work surface.
4. Lifting and lowering: press the & quot;lifting & quot; button to start the motor, the motor rotates, the hydraulic system works, the oil cylinder extends, and the platform lifts; when the lifting is required to work, press the motor & quot;stop & quot; button, the platform stops lifting , You can work, if you do not press the & quot;stop & quot; button, the travel switch works when the platform rises to the calibrated height, the platform stops at the calibrated height. After the work is completed, press the & quot;Descent & quot; button, the solenoid valve is activated, and the oil return of the cylinder is connected, and the platform is lowered by its own weight.
5. Overloading is strictly prohibited during the use of Scissor Lift Parts. Operators on the platform must not move during the lifting and lowering process.
6. When moving or pulling the hydraulic platform, the supporting legs should be retracted and the platform should be lowered to the lowest position. It is strictly forbidden for the operator to move the platform when it is in a high position.
